Original Placement
Place your original face down on the Original Glass.
Different methods are used to load your originals depending on the type of
your originals and whether the copier is equipped with an
Automatic/Duplexing Document Feeder AF-3/AFR-7 (option).
Know the type of your originals and your copier system configuration and use
the appropriate procedure.
1139O0050A
Sheet Originals (of a Standard Size)
Raise the Original Cover.
Place your original face down on
the Original Glass and align its
rear left corner with the
marker on the Original Width
Scale on the left side of the
platen.
Gently lower the Original Cover.
▼
1
2
1139O0070A
Place your original in the same
way as the sheet originals.
Place a blank sheet of paper of
the same size as the original on
the original. Then, lower the
Original Cover.
Highly Transparent Originals
1
2
If this is not done, the copy
produced may be of very poor
quality.
NOTE
2. Basic Job Setting
Chapter 3
Making Copies
38
To Next Page
Loading...
