Minolta EP1080 - Manual Bypass Copying

Manual Bypass Copying
Use the manual bypass copying capability of the copier when you want to make
copies on paper not loaded in any Drawer, or on transparencies, translucent paper,
or any other special paper.
If the copier is equipped with a Multi Bypass Table (option), you can load more
than one sheet of such paper to make a continuous run.
You can also use the Cover Mode capability if the Multi Bypass Table is used
with Automatic/Duplexing Document Feeder AF-3/AFR-7 (option).
◆
Types of Paper
•
Plain paper (weighing 60 to 90 g/m
2
)
•
Heavyweight paper (weighing 90 to 157 g/m
2
)
•
Transparencies, translucent paper
◆
Paper Size
•
Width: 100 to 297 mm
•
Length: 140 to 432 mm
◆
Capacity
•
Plain paper, heavyweight paper, transparencies, translucent paper ... 1 sheet at a time
<Multi Bypass Table>
•
Plain paper ... Approx. 50 sheets
•
Heavyweight paper, transparencies, translucent paper ... Approx. 20 sheets
1139O0150A
Place the original on the Original
Glass and make the control panel
settings.
Insert the copy paper into the
copier.
◆
This automatically starts the
copy cycle.
Using the Manual Bypass Table
1
2
2. Basic Job Setting
•
Insert the copy paper one sheet at a time.
•
Do not insert a sheet of paper while the copier is warming up or in a
multi-copy cycle.
•
The Auto Paper Mode, Auto Size Mode, Book copying, any of the Finishing
modes, 2-sided copying, Margin Mode, or Cover Mode cannot be selected for
manual bypass copying.
NOTES
Chapter 3
Making Copies
62