1139O0130A
Place the original on the Original
Glass and make the control panel
settings.
Swing down the Multi Bypass
Table and slide the Paper Guide
Plate to the size of the copy
paper.
Using the Multi Bypass Table
1
2
Pull out the Multi Bypass
Table Extender if you are
using larger paper.
NOTE
1139O0140A
Place a neat stack of copy paper
on the Table and insert it into the
copier as far as it will go.
3
•
Fan the paper stack well
before inserting if you are
using transparencies or
translucent paper.
•
Correct curl if you are using
heavyweight paper.
NOTES
1139O2360A
Press the Start Key to start the
copy cycle.
4
•
Do not insert the paper while the copier is in the warm-up cycle or a
multi-copy cycle.
•
The Auto Paper, Auto Size, Book, Finishing, 2-Sided Copy, and Margin
cannot be selected for manual bypass copying.
NOTES
2. Basic Job Setting
Chapter 3
Making Copies
63
To Next Page
Loading...
