Action
The copier is in the Energy Saving Mode.
Press any Key on the Control Panel to cancel the Energy Saving Mode.
➭
p. 31
The copier is now warming up. Please wait.
➭
p. 29
Take the necessary steps for each Indicator.
➭
p. 108
The conditions for the set copy mode are not met.
Refer to
NOTES in the setting procedure of each mode and correct the setting as
necessary.
Auto Paper Mode
➭
p. 57
•
The paper size automatically selected has run out.
•
The paper size automatically selected is not loaded in any of the Drawers.
•
The original size is unknown (the copier is unable to take measurements).
•
When the 2-sided copying mode is used in combination, a paper size not covered by the
copier specifications is automatically selected.
•
When the Sort, Group, or Sort-and-Staple Mode is used in combination, a paper size not
covered by the copier specifications is automatically selected.
Auto Size Mode
➭
p. 52
•
The zoom ratio selected automatically falls outside the copier specifications.
Sort, Group, Sort-and-Staple Mode
➭
p. 74
•
The number of copy sets or stacks exceeds the copier specifications.
•
A paper size not covered by the copier specifications is selected.
2-Sided Copying Mode
➭
p. 71
•
The number of copies set to be made exceeds 50.
•
An attempt is made to start a copy cycle in a different mode with paper left in the
Duplex Unit.
Page-by-Page Book Copying Mode
➭
p. 70
•
An illegal paper size is selected.
User’s Choice Mode
➭
p. 94
•
An illegal setting value is defined.
•
The paper size set as the priority size is not loaded in the copier.
2. The Copier is Not Activated
Chapter 6
Troubleshooting
157
To Next Page
Loading...
