Minolta EP1080 - Page 55

1136O804AA
Original
Positioning Plate
Original
Width Scale
Raise the AF-3/AFR-7 and place
your original face down on the
Original Glass. Align the rear left
corner of the original with the
marker on the Original Width
Scale and press the rear edge of
the original up against the
Original Positioning Plate placed
at the rear side of the Original
Glass.
Gently lower the AF-3/AFR-7
and start the copy cycle.
1
2
For Originals Not Suitable for Use in AF-3/AFR-7
The Sort-and-Staple or Manual Staple Mode cannot be used in the Mixed
Original Detection Mode.
NOTE
Manual
Staple
Sort
Sort &
1
Mixed Orig. Det.
211
2in1
1
1139O2632A
Press the Mixed Original
Detection Mode Key.
This completes the setting
procedure.
Now, make your copies by
following the steps given in
"BASIC COPYING
OVERVIEW" on p. 36.
4
1139O0100A
Swing the Document Exit Tray
back again and pull out the
Document Exit Tray Extender.
3
2. Basic Job Setting
Chapter 3
Making Copies
43