•
If the Paper Select Key is pressed in the Auto Paper Mode, it automatically
cancels the Mode to select the Manual Mode.
•
The copier has been factory-set to select the Auto Paper Mode in the initial
mode. This priority mode can be changed to the Auto Size Mode or Manual
Mode by User’s Choice.
NOTES
Initial mode
➭
p. 32
User’s Choice
➭
p. 96
A3
A4
A4
B4
B5
FLS.
Inch
Auto
A5
1139O0252
1139O0252A
•
If the paper of the right size has run
out in the Auto Paper Mode, both the
Paper Size Indicator (arrow ) and
Add Paper Indicator light up as
shown on the left.
If this happens, add paper of the
right size or cancel the Auto Paper
Mode and use the Manual Mode to
make copies.
If none of the Drawers are loaded
with paper of the right size, both the
Auto Paper Mode Indicator and
Paper Size Indicator (arrow )
blink as shown on the left.
In this case, load a drawer with
paper of the right size or cancel the
Auto Paper Mode and use the
Manual Mode to make copies.
* Zoom Ratio Table (Original Size to
Paper Size)
➭
p. 53
▼
▼
A3
A4
A4
B4
B5
FLS.
Inch
Auto
A5
1139O0262A
1139O0262A
Automatic Drawer Switching
If the Drawer currently selected for use runs out of paper and there is another
Drawer loaded with paper of the same size and in the same direction, the copier
automatically selects that second Drawer to permit an uninterrupted copy cycle.
This feature is a great advantage when you need to make a large number of
copies on the same size paper. For example, an uninterrupted copy cycle is
possible to make up to 500 copies by using the AF-3 or AFR-7 if the 1st and
2nd Drawers are loaded with paper of the same size and in the same direction.
Useful Tip
2. Basic Job Setting
Chapter 3
Making Copies
57
To Next Page
Loading...
