Panel Display in 2-Sided Copying
1139O4760A
▲
The copier starts a 2-sided copying
cycle when you select a mode to
make 2-sided copies (i.e., 1 2 or
2 2) and press the Start Key.
On completing the first copy cycle,
the copier stores the 1-sided copy in
the Duplex Unit, getting ready to run
the second copy cycle.
At this time, one of the Paper Port
Indicators (for convenience sake, let
us call it the 2-Sided Copy Indicator)
lights up to indicate that the copy has
been stored in the Duplex Unit.
▲
Canceling 2-Sided Copying
When the copier has completed the first copy cycle of a 2-sided copying cycle,
there is a 1-sided copy stored in the Duplex Unit.
If you want to cancel the 2-sided copying mode at this point, you need to feed the
1-sided copy out of the Duplex Unit and copier onto the Copy Tray.
1139O5060A
Press the Panel Reset Key.
◆
The 2-Sided Copy Indicator,
which has stayed lit up, starts
blinking.
1
1139O2360A
Press the Start Key.
◆
This feeds the copy in the
Duplex Unit out through the
copier onto the Copy Tray.
Then, the 2-Sided Copy
Indicator goes out, indicating
that the copier has left the
2-sided copying mode.
2
4. System Job Setting
Chapter 3
Making Copies
73
To Next Page
Loading...
