Auxiliary Functions
4
EP1085 4-11
U-23 Auto Panel Reset for Plug-In Counter
Determines whether the copier is set into the initial mode when the Plug-
In Counter is pulled out after a copy cycle has been run using the Plug-In
Counter.
U-24 Sort/Non-Sort Auto Switching ON/OFF
Specifies whether to enable automatic switching between the Sort and
Non-Sort Mode under the following conditions when the copier is
equipped with the Sorter and the Automatic Document Feeder.
Conditions
The copy cycle is initiated using a single original in the Sort Mode.
The copy cycle is initiated to make two or more copies using two or more
originals in the Non-Sort Mode.
U-28 Auto Shut OFF Timing
Select whether or not to enable the Auto Shut OFF Function that turns
power off automatically after the lapse of a given period of time after a
copy cycle has been completed or a key on the control panel has been
operated. In the initial setting, the Auto Shut OFF Function is activated
after 30 min.
If you want to disable the Auto Shut OFF function, first select “1” in the
Non-Auto Shut OFF Mode then select “0” in this Mode, see page 4-7.
Setting Description Initial Setting
0Copierisnotreset.
1 Copier is initialized when the Plug-In Counter is
pulled out.
Setting Description Initial Setting
0 Sort/Non-Sort switching OFF
1 Sort/Non-Sort switching ON
Setting Description Initial Setting
10 Disabled*
1 Enabled : 1 min.
2 Enabled : 2 min.
3 Enabled : 3 min.
::
98 Enabled : 98 min.
99 Enabled : 240 min.
To Next Page
Loading...
