Interleaf EP5000/EP4000 SWITCHES ON PWBs, TECH. REP. SETTINGS
97.04.01
S-11
1156SBS040403A
[3/6]
Touch Panel
Display
Setting (The default is .)
Highlighted
Auto Panel Reset Specify the default exposure mode selected automatically when power is turned
ON or the Panel Reset key pressed.
1 min.
30 sec. 2 min.
5 min.
3 min. No Reset
Energy Saver Mode Set the time it takes the copier to enter the Energy Saver mode after a copy cycle
has been completed or the last key operated. Use the 10-Key Pad to set the time
(1 to 240 min.).
1 to 240 (15 min.) OFF
NOTE: The OFF setting is available for European areas only.
Drum Dehumidifier Select whether to allow the copier to enter the Drum Dehumidifier mode automat-
ically after it has been turned ON, or not.
ON OFF
Counter Removal Select whether to reset the panel or not when the Plug-In Counter is pulled out
of the copier, a magnetic card is pulled out of the Data Controller, or the Access
Mode key is pressed.
ON OFF
1156SBS040404A
[4/6]
Touch Panel
Display
Setting (The default is .)
Highlighted
Intelligent Sort
Select whether to turn “ON” or “OFF” the function that automatically switches be-
tween Sort and Non-Sort according to the number of originals loaded in the docu-
ment feeder.
ON OFF
NOTE: This function is enabled when “Mixed Orig. Detection” is
turned “OFF” and the copier is in the Auto Paper or Auto
Size mode.
Confirmation Beep Select whether to turn “ON” or “OFF” the beep that sounds each time a key on
the control panel is pressed or that on the Touch Panel is touched.
ON OFF
Original Thickness Select whether to allow (“Thin”) the user to make copies from thin originals in
addition to the standard ones or not (“Standard”) using the document feeder.
The orginal is pressed against the
Original Width Scale when stopped.
The original is not pressed against the
Original Width Scale when stopped.
Standard Thin
Smaller Originals Select whether to enable (“ON”) a copy cycle or not (“OFF”) when it is initiated
by pressing the Start key with an original of the smallest detectable size (metric
areas: A5 or smaller; inch areas: Letter or smaller) placed on the Original Glass.
The copy cycle is run using the paper
loaded in the default paper source.
A warning message is given and the
copier inhibits the start of this copy
cycle.
OFFON
NOTE: The default setting is OFF for the metric areas and ON for the inch
areas.
To Next Page
Loading...
