E7E6
Names of Parts and DisplaysNames of Parts and Displays
For the purpose of explanation, the diagram above shows
all indicators that light up on the LCD.
7. Digital readout
8. Shutter speed/framing-
rate display
9. Analyze scale
10.Flash light measuring
indicator
11.Film speed display
12.Measuring mode
display
7. Digital readout
When the measurement data display unit is set to "FNo." or "FNo. direct
reading," the f-number (FNo.) is displayed. When the display unit is set
to "EV," the exposure value (EV) is displayed in 0.1-stop increments. For
flash light measurement, only the FNo. display mode is available.
Holding down the incident light measuring button or spot measuring
button (which activates the brightness difference function) in latitude
display mode causes
∆EV (deviation from the standard exposure) to be
displayed. When the measuring button is released, the standard
exposure is displayed.
8. Shutter speed/framing-rate display
Displays the shutter speed or frame rate specified with the Up/down dial.
When shutter speed is between 0.6 to 50 sec, s is displayed; between 1
min. and 30 min., m is displayed.
Setting range: Shutter speed: 30 min. to 1/16000 sec. (1, 1/2, 1/3
stops)
Framing-rate: 8, 12, 16, 18, 24, 25, 30, 32, 64,128 f/s
9. Analyze scale
Displays the proportion of flash light in the total exposure value obtained
from flash light measurement. For more information on the Light Ratio
Analyze function, see p. 36.
10. Flash light measuring indicator
This indicator appears together with the analyze scale in CORD and
NON CORD mode.
11. Film speed display
Displays the film speed setting.
Holding down the instant film ISO button displays the indicator.
Setting range: ISO 3 to ISO 8000
12. Measuring mode display
Displays one of the three measurement modes (AMBI, CORD or NON
CORD) according to the setting of the MODE button.
Repeatedly pressing the MODE button cycles the measurement modes
in the following sequence:
AMBI ➞ CORD ➞ NON CORD ➞ AMBI ➞
flashmetervieng.qx3302.12.259:21PMページ6