Installation and Programming Manual
Mircom Technologies Inc All Rights Reserved LT-1034 Rev.1
Page 29 of 54
5.7 Entering the Date and Time
Access Level 1
Select [ADMINISTRATION] [SET DATE/TIME]
The date is MM/DD/YY format
The time is 12 hour HH:MM
When the cursor is over the AM/PM digit, press 1 to change to AM, or press 7 to change to PM. Press ‘ENT’,
then ‘BCK’ out of programming. The time must be changed manually for Daylight Savings Time adjustments.
5.8 Alarm and Trouble Logs
Access Level 1
There are a total of 900 entries combined for alarm and trouble log archival. Once this number is surpassed, the
oldest entry will be dropped from history and replaced with the newest.
Select [ADMINISTRATION] [VIEW LOGS]
5.9 Resetting the NMC to the Factory Defaults (required after an NMC firmware update)
Access Level 3
To reset the Factory Defaults, select [CONFIGURE] [CONFIGURE NMC] [NMC NETWORK] [FACTORY
DEFAULT].
There will be a 1 second delay between displays of ‘Resetting Pass codes’, Followed by ‘Resetting System
Parameters’, ‘Resetting ISD Settings’ (20 sec),‘Resetting Trouble Logs’, ‘Resetting Alarm Logs’, completing by the
final acknowledgement of ‘Factory Defaults Set’.
SET DATE/TIME
>VIEW LOGS
CHANGE MSG UNIT
UP DWN ENT BCK
DISPLAY VERSION
>ADMINISTRATION
TEST
UP DWN ENT BCK
ALARM LOGS
TROUBLE LOGS
UP DWN ENT BCK
>SET DATE/TIME
VIEW LOGS
CHANGE MSG UNIT
UP DWN ENT BCK
DISPLAY VERSION
>ADMINISTRATION
TEST
UP DWN ENT BCK
WARNING:
RESET FACTORY
DEFAULTS?
CONT BCK
>FACTORY DEFAULT
UP DWN ENT BCK
>NMC NETWORK
SYST PARAMETERS
CONFIG RELAYS
UP DWN ENT BCK
>CONFIGURE NMC
CONFIGURE ISD
UP DWN ENT BCK
RESETTING NMC TO
FACTORY DEFAULTS
PLEASE WAIT…..
CONT BCK
ADMINISTRATION
TESTS
>CONFIGURE
UP DWN ENT BCK
11/23/04 17:35AM
DD/MM/YY HH:MM
< > ENT BCK