Adding and Configuring Amplifiers/Zones
22
Editing Amplifier Properties
To modify an amplifier and its zones (sections),
1. Select “Amplifiers/Zones” from the left pane. The right pane displays the Amplifiers/Zones list.
2. Select a zone, then
•Select Edit-->Properties from the main menu, or
• Double-click it. The Amplifiers/Zones Properties Window displays.
3. Edit the Amplifier/Zones properties:
• You can scroll through the amplifier sections through the Section up and down arrow buttons.
• You can change the Amplifier Model (which might change the number of sections), and the Cabinet and
Slot number.
4. Click OK to save the changes and return to the Main Window. The configuration utility will check the amplifier
information when you click OK.
Labeling amplifiers
will make it easier
for you to configure
the system
Shows next available
unused switch
Shows the next
available cabinet
and slot
To Next Page
Loading...
Need help?
General
