Mircom QX-5000 Series - Editing the QIF-1000 Properties; Setting a Local QIF-1000

Adding and Configuring a QIF-1000
28
Editing the QIF-1000 Properties
To edit a QIF-1000,
1. Select “QIF-1000” from the left pane. The right pane displays the QIF-1000 message list.
2. Select Edit-->Properties from the main menu. The QIF-1000 properties window displays.The Local checkbox
will only be available either if the edited device is designated as local or no local ID is been added.
3. Edit the QIF-1000 settings as desired. Click OK to save your settings and return to the Main Window.
Setting a Local QIF-1000
To set a QIF-1000 as local,
1. Select “QIF-1000” from the left pane. The right pane displays the QIF-1000 message list.
2. Select Edit-->Properties from the main menu. The QIF-1000 properties window displays.The Local checkbox
will only be available either if the edited device is designated as local or no local ID is been selected. If another
QIF-1000 was already designated as local, you must un-select the checkbox from the other QIF-1000 and
check it in the new one.
firealarmresources.com