34 TX3 Telephone Access System Programming Manual Version 2.7
LT-979 Copyright 2018
Configuration
Note: If you accidentally enter the wrong character while configuring an
apartment number, press * once to backspace.
For example, to enter the apartment number “23B”,
a. Press “2” once for the “2”, and then wait for the cursor to advance.
b. Press “3” once for the “3”, and then wait for the cursor to advance.
c. Press “2” six times for the letter “B”.
d. Press the telephone key to save and continue.
4. Once you have entered the apartment number and pressed the telephone
key to accept, the Enter Dial Code screen appears. The list of all screens
that you need to configure to add a resident is given in Table 1. Press the
telephone key to save the information for a screen and then advance to the
next screen.
Note: The keypad functions differently for entering a resident’s name (see
Figure 3) and for entering a resident’s phone number (see Figure 4).
Refer to these figures when entering information for those screens.
Figure 3. Keypad commands for entering a resident name.
press once = comma
press twice = dash
press 3 times = left bracket
press 4 times = right bracket
press 5 times = /
press 6 times = &
press 10 times = 1
press 0 once to delete a character
press 0 twice = 0
press * once = move cursor back
press # once = move cursor forward
For Resident Name Entry Only
press 9 times = *
To Next Page
Loading...
