Mircom TX3 Series - 3.1 TX3 System Overview and Configurations

Configuration
Version 2.7 TX3 Telephone Access System Programming Manual 37
LT-979 Copyright 2018
2.8.2 Using keyless entry codes
To enter the premises with a keyless entry code, you must first be in normal mode.
While in normal mode, press 0, after which point you are prompted with “Enter
keyless code”. The keyless code is a numeric value from 1 to 999999.
To enter your keyless code
1. Press 0. The keyless enter code appears.
2. Enter your keyless code.
2.8.3 Selecting a ring pattern (NSL System only)
The ring pattern selection is part of the Database Menu.
Enter Elev Rest Code
[_ _]
YES YES Enter the elevator restriction relay number for the resident.
Hide Display
[x] Display
YES YES This feature turns the resident information display ON or
OFF. When OFF the resident’s information is only
displayed in configuration mode. Use arrow keys to scroll
and press # or * to make a selection.
Ring Pattern
[x] Ring Pattern 1-5
YES N/A Enter the ring pattern for the resident. See Table 2 for
available ring patterns. The default is 1. Use arrow keys to
scroll and press # or * to make a selection.
Table 1: List of Screens
Table 2: Available Ring Pattern
Ring
Pattern
Available Ring Pattern
1 2s ON 4s OFF standard
ring A
2 800ms
ON
400ms
OFF
800ms
ON
4s OFF distinct
ring B
3 200ms
ON
400ms
OFF
200ms
ON
400ms
OFF
800ms
ON
4s OFF distinct
ring C
4 200ms
ON
400ms
OFF
800ms
ON
400ms
OFF
200ms
ON
4s OFF distinct
ring D
5 One single ringing burst