Mircom TX3 Series - Page 40

40 TX3 Telephone Access System Programming Manual Version 2.7
LT-979 Copyright 2018
Configuration
Table 3 describes the information you will need to auto program the panel.
To use the auto program
1. Scroll the arrow to “Auto Program” database menu and press the enter
(telephone) key. The display will now show the following message:
2. Use the up arrow to move from number of residents in increments of 5 to
the desired number. The maximum depends on the TX3 Model (it can be
200, 1000 or 2000).
Note: Only 200 names can be added at a time.
Table 3: Auto Programming Information
Programming Menu
NSL
System
ADC
System
Explanation/Description
Number of Records
[____]
YES YES
Enter the total number of residents to auto
program (4 digits). Scroll up or down to the
desired number, then press enter (telephone
key). Must be 10 or more.
Enter Resident
Name
[____________]
YES YES
Enter the resident’s name (maximum 10
characters).
Start Dialcode
[____]
YES YES
Enter the start number of Dial Codes to auto
program. The starting code will be entered in
increments of 1, up to the number of residents
entered.
Start Keyless Code
[____]
YES YES
Enter the start number of the keyless codes, if
used. The starting code will be entered in
increments of 1, up to the number of residents
entered. These codes are used by the visitors to
enter without calling the resident.
Line Number to use
[__]
YES YES
Enter the Line number you wish for this lobby
unit to connect to. This Line numbers will be
used by the number of residents entered. Lines
1 to 5 are available.
Start Relay Number
[____]
YES N/A
Enter the start relay number to auto program.
The starting relay number will be entered in
increments of 1, up to the number of residents
entered. Please note that the relay number
starts at 1 for the first relay.
Number of Records
< 010>