miRider One - Page 25

25
· Always lock the battery in the frame to prevent the battery from falling out.
· Alwaysfolddownthebatteryhandlesothehandleisushwiththebatterybefore
unfolding the frame to prevent damage to the battery handle.
· When the frame is folded, only move your e-bike forward. Moving your e-bike
backwards causes the crank arm to rotate which may damage the frame.
· Do not lubricate inside the seatpost. The seatpost has factory installed grease and does
not need lubrication in between service intervals.
· Do not use aggressive detergents that may damage the e-bike.
· Do not immerse the e-bike in water or clean the e-bike with a high pressure cleaner.
· Always fully charge the battery before storing to prevent diminishing the battery life.
· Alwayschargethebatterywithinatemperaturerangeof10°C-45°C.
· Always plug the charger into the battery's charging port before plugging the charger
into the power outlet. Always disconnect the charger from the power outlet before
removing the charger from the battery’s charging port.
· Listen to the sound your e-bike produces. If something doesn’t sound right or you feel
any wobbles/shakes, stop riding your e-bike and identify the problem.
· Never forcefully close the frame latch. If the frame latch does not close properly, check
that the frame safety lock is pressed.
· Do not forcefully close the clamps. Overtightened clamps can fail and snap.
· Do not overtighten the bolts. Overtightened bolts can fail and break.
· Do not let the rear wheel dangle from the power cable when maintaining the wheel
using a cycle maintenance stand. Letting the rear wheel dangle by the power cable may
cause irreparable damage. Always disconnect the power cable and wheel completely
from the bike before commencing maintenance.