Wall mount version (LDM 320W):
Figure 2 - LDM 320W
2.2. General Reader Operation
The dosimeter reader is connected to a "host" PC through a USB link.
Users operate the reader by computer via a USB cord. Most commands are intended for
communication with a dosimeter present in the reader coverage area.
Dosimeter reader typical use:
"Office" use: The reader is used to configure the dosimeters and ommunicate to the PC
the dosimeter's stored measurements and event histories.
"Access control" use: The reader is used to identify presented dosimeters, check them
for good condition, switch them to "Measurement" (Run) mode at "area entry" and to
"Pause" mode at "area exit", and retrieve their essential data (doses, dose rates, etc.).
LDM 320 Description
150532EN-C
Publication, traduction et reproduction totales ou partielles de ce document sont rigoureusement interdites, sauf autorisation écrite de nos services.
The publication, translation or reproduction, either partly or wholly, of this document is not allowed without our written consent. Format 112175C.
3
To Next Page
Loading...
