Mirion Technologies LDM 320 - Maintenance; Failure Analysis; Replacement of Sleeve

5. Maintenance
5.1. Failure Analysis
Symptoms Analysis Action
No communication with the
PC
Verify that the reader is
powered.
Verify good connection with
the USB cable.
Start again after checking.
Verify the proper
configuration of the PC port.
Configure the port. If the fault
persists, contact Mirion
Technologies.
No data exchange with the
dosimeter
Eliminate all sources of
electromagnetic emissions.
Verify that the reader is
powered.
LED power lighting
redallumé rouge
The reader is in an error
state.
Disconnect and connect the
USB cable.
5.2. Replacement of Sleeve
The LDM 320W sleeve can be replaced in the event of breakage (see §7.1 for spare parts
part numbers).
Warning: Prior to performing any maintenance operation, make sure that the LDM is disconnected
from the PC (USB disconnected).
LDM 320 Maintenance
150532EN-C
Publication, traduction et reproduction totales ou partielles de ce document sont rigoureusement interdites, sauf autorisation écrite de nos services.
The publication, translation or reproduction, either partly or wholly, of this document is not allowed without our written consent. Format 112175C.
19