Instruction Manual MIT-SCAN-T3 Version 02/2021
Reflectors supplied by MIT are checked and verified thru control tests.
A certificate is issued for each batch. If required, this certificate may be
viewed or requested at MIT by the user (s. Fig. 6). MIT plates are
imprinted with the MIT logo to avoid confusion with any reflector
imitations not validated for the use of MIT-SCAN-T3.
Please ask MIT for a list with tested suppliers of circular plates in your
country.
Attention: Measuring device and reflectors are one unit. If
unauthorized or damaged reflectors are used, the accuracy of
the layer thickness measurement system can’t be guaranteed.
There may be significant variations between measured
thickness and real thickness.
Fig. 6 Reflector quality
validation certificate
To Next Page
Loading...