MIT MIT-SCAN-T3

Instruction Manual MIT-SCAN-T3 Version 02/2021
Page 40
Error message
What to do?
Low battery!
Reload the battery promptly
Empty battery!
Measurements cannot be performed. Reload or
exchange battery.
No GPS signal!
Continue measurement and save data without GPS
signal.
Alternatively wait until device will receive a GPS signal.
Data memory full!
Measurements cannot be saved.
Move slower!
Evaluation was still possible. However, a slower pace is
recommended.
Movement too fast.
Calculation of layer thickness failed. Repeat
measurement run.
No reflector found!
Analysis of measurement signal was not able to find a
reflector. Repeat search and measurement of reflector.