81
8575
8575
N/B Maintenance
N/B Maintenance
Figure 2-8 Remove the fan’s power cord
Reassembly
1. Carefully, align the arrowhead corner of the CPU with the beveled corner of the socket, then insert CPU
pins into the holes. Place the lever back to the horizontal position and push the lever to the left.
3. Replace the keyboard .Then replace easy start buttons cover.
2. Connect the fan’s power cord to the system board, fit the heatsink onto the top of the CPU and secure with
four screws.
4. Disconnect the fan’s power cord from the system board, then lift up the heatsink. (Figure 2-8)
5. Push the lever to the right. Then lift up the lever to the vertical position. Finally, Remove the existing CPU.
(Figure 2-9)
Figure 2-9 Remove the CPU
To Next Page
Loading...
