Mitel 3000
Administrator’s Manual
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “T1 (RBS) or PRI (ISDN)” is displayed.
• Select T1 (RBS)
• Select “Line Type”.
• Select “E&M” line type.
• Select one of the options listed above.
The default setting is “None”; A solid diamond indicates current selection.
For DID Line Types the following options are available: -
None - No Service Type is set.
ANI
DNIS
*ANI*
*DNIS*
*ANI*DNIS*
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “T1 (RBS) or PRI (ISDN)” is displayed.
• Select T1 (RBS).
• Select “Line Type”.
• Select “DID” line type.
• Select one of the options listed above.
The default setting is “None”,
For Loop Start Line types the following options are available: -
None - No Service Type is set.
Caller ID.
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “T1 (RBS) or PRI (ISDN)” is displayed.
• Select T1 (RBS).
• Select “Line Type”
• Select “Loop Start” line type.
• Select one of the options listed above.
The default is that no service type is set.
If Ground Start is selected no additional menu is presented. There are no services available on Ground Start
lines.
Programming the Start Types
When E&M Service Type is selected four Start Types are available.
Immediate.
Wink.
Delay Dial.
Dial Tone.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “T1 (RBS) or PRI (ISDN)” is displayed.
• Select T1 (RBS).
120
To Next Page
Loading...
Need help?
General
