Mitel 3000 - Lines Settings Options

Mitel 3000
Administrator’s Manual
Lines Settings Options
If “Lines” is selected, the following screens appear:
1. 2.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
3. 4.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
Select option
- CID Programming
- PSTN Programming
- Exit
If “Lines” is selected and T1/E1 PRI is programmed, the following screens appear:
1. 2.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
3. 4.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
Select option
- PRI Programming
- Call Routing Priority
- T1 (RBS) or PRI (ISDN)
5. 6.
Select option
- T1 Channels
- System Voice Mail Box
- CID/ANI Table
Select option
- DID/DNS Table
- Exit
If “Lines” is selected and E1 PRI is programmed, the following screens appear:
1. 2.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
3. 4.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
Select option
- CID Programming
- DID Programming
- Accept on Busy
5. 6.
Select option
- PSTN Programming
- Call Routing Priority
- PRI Programming
Select option
- System Voice Mail Box
- Exit
Note: Accept on Busy only applies when a T1/E1 card is installed and the E1 PRI is programmed.
142