To Next PageTo Next Page
Why Mitel 3000 Telephone System is not seizing a line for outgoing calls?
If your Mitel Telephone System isn't seizing a line for outgoing calls, check the following: 1. Verify if the line has been programmed for incoming calls only. 2. Ensure the line is equipped in programming. 3. Confirm that the key is programmed for line access.
What is the Mitel Telephone System phone reset code?
Remember the simple phone reset code 739, which can be dialed from any extension phone.
Why Mitel Telephone System Caller ID shows the digit 9 before the number?
The 9 is inserted when the number is received from an external call.
Why no Caller ID on Mitel 3000 when connected to a dataport?
The data port is primarily intended for PC modems rather than standard telephones.
General| Brand | Mitel |
|---|---|
| Model | 3000 |
| Category | Telephone System |
| Language | English |
Steps to select PPPoE connection type.
Configuration screen for PPPoA username and password.
Configuration for Virtual Path and Circuit Identifiers.
Manual entry for VPI/VCI values.
Steps to select DHCP connection type.
Steps to select Manual connection type.
Steps to select Static IP configuration.
Screen for entering static IP addresses and subnet mask.
Prerequisites and checks before programming IP extensions.
Steps to configure endpoints as IP extensions.
Screen for entering MAC addresses and passwords for extensions.
Steps to change the VoIP interface for LAN-only extensions.
Explains codec choices (G.711 vs. G.729) for IP extensions.
Configuration of proxy server details for VoIP trunks.
Steps to program IP endpoints as VoIP trunks.
Steps to make a server accessible from the Internet via DMZ.
Procedure for assigning a static IP to a server.
Screen to create a new fixed IP host entry.
Explains reserved mappings for port forwarding and NAT.
Creating exceptions to NAT rules for specific servers.
Selection of ISDN modes (Disabled, Backup, Enabled).
Reiteration of ISDN mode selection.
Security settings for the wireless network, including SSID broadcast.
Configuration of SSID broadcast and security options.
Settings for authenticating wireless PCs.
Recommended security settings for maximum protection.
Configuration for 64-bit WEP encryption key.
Configuration for 128-bit WEP encryption key.
Setup for WPA security with a passphrase.
Steps to back up module settings to a PC.
Steps to restore module settings from a saved file.
Saving configuration files to PC.
Browsing for and restoring configuration files.
Enabling or disabling the firewall and intrusion detection.
Explains pre-defined security levels and their filters.
Changing the security level of the firewall.
Configuring intrusion detection settings to block attacks.
Parameters for configuring blacklisting and intrusion detection.
Overview of the DHCP server functionality.
Enabling or disabling the DHCP server.
Performing diagnostic tests on the ADSL connection.
Displays results of ADSL diagnostic tests.
Updating the module with new firmware.
Resets the module to factory default settings.
