Mitel 3000 - 64 Bit WEP Encryption

Mitel 3000
Broadband Module Manual
50
The recommended encryption is to use WPA. This uses a phrase of between 8 and 63
characters.
64 bit WEP encryption
Select 64 bit encryption on the wireless network
Click Next>
Enter a 10 hexadecimal character key (hexadecimal characters consist of the characters A –
F, and the numbers 0 – 9).
Make a note of this key, as it must be entered into every PC that connects to the WLAN. The
key should be entered in the table in Appendix A for easy reference.
Click Next>, this takes you to Address Authentication (page
51).
128 bit WEP encryption
Select 128 bit encryption on the wireless network
Click Next>
Enter a 26 character hexadecimal key (hexadecimal characters consist of the characters A –
F, and the numbers 0 – 9).
Make a note of this key as it must be entered into every PC that connects to the WLAN. The
key should be entered in the table in Appendix A for easy reference.
Click Next>, this takes you to Address Authentication (on page
51).
WPA on the wireless network *Recommended
Select Wi-Fi Protected Access (WPA) on the wireless network
Click Next>.
Enter a pass phrase of between 8 and 63 characters.