Mitel 3000
Broadband Module Manual
29
• QoS: Signalling DSCP – this parameter is only used on a Quality-of-Service enabled
network and will be provided by the network administrator. Where a standard Internet
connection is used, leave this parameter at the default setting of 0
• Outbound Server – enter a URL or IP address
• Outbound Server Port – the default value is 5060. If a different port number is used,
enter it here.
• Outbound Server Transport - select TCP or UDP from the drop-down menu
• VoIP Interface – the drop-down menu has three options. Select ipwan if the on-board
ADSL modem is used for broadband. Select iplan if the IP extensions are on the LAN
and no broadband service is provided. Select ipdmz if the ETH/DMZ port is used for
broadband. The iplan option is not used for IP trunks
• Only accept calls to Registered Endpoint numbers – leave this option unchecked.
• Click Next >
Select Confirm Changes.
Trunk Settings
A broadband connection must first be established before the IP Endpoints can be
programmed. The VoIP service provider will supply the username and password for each
trunk.
Select VoIP from the Setup menu.
The following screen is displayed:
To Next Page
Loading...
