Mitel 3000 - Adding Firewall Port Filters; Steps to Add TCP;UDP Port Filters

Mitel 3000
Broadband Module Manual
68
This screen lists the filters currently in effect for that interface.
Adding Port Filters
Select Add TCP or UDP Filter.
The following screen is displayed:
Enter the following parameters:
- Source address.
- Mask is always 255.255.255.255.
- IP Destination address.
- Mask is always 255.255.255.255.
- Protocol, TCP or UDP.
- Source port or range of ports (associated with source IP address).
- Destination port or range of ports (associated with destination IP address).
- Direction, Inbound or Outbound, Allow or Block for each.
Select Apply.
Save the new configuration.
Restart the module.