Mitel 3000 - Adding Raw IP Filters and Host Validators; Steps to Add Raw IP Filters; Host Validators for Blocking Hosts

Mitel 3000
Broadband Module Manual
69
Adding Raw IP Filters
Filters based on IP address and protocol only can be added to the security level displayed.
Select Add Raw Filter.
Enter the following parameters:
- IP Source address and Subnet Mask.
- IP Destination address and Subnet Mask.
- IP Protocol.
- Direction, Inbound or Outbound.
- Allow or Block
Select Apply.
Save the new configuration.
Restart the module.
Host Validators
Traffic to or from specific hosts can be blocked by the firewall.