Mitel 3000 - Incoming Calls Only When T1 Is Programmed; Incoming Calls Only When T1 Pri Is Programmed; Incoming Calls Only When E1 Pri Is Programmed

Mitel 3000
Administrator’s Manual
INCOMING CALLS ONLY WHEN T1 IS PROGRAMMED
If the T1 lines are programmed as E&M, Loop Start or Ground Start then all the lines are shown when
“Incoming Calls Only” is selected.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “Incoming Calls Only” is displayed.
• Select “Incoming Calls Only” option.
• The menu updates to show all relevant T1 lines.
• Select the required lines to be reserved for incoming calls only.
• In default no lines are programmed.
Note: If any T1 lines are programmed as DID they are available as incoming only lines and are not
presented on the display. They cannot be programmed to accept outgoing calls.
INCOMING CALLS ONLY WHEN T1 PRI IS
PROGRAMMED
When Incoming only is selected when the switch is equipped with a PRI the display updates showing the
B-Channels and CO lines.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “Incoming Calls Only” is displayed.
• Select “Incoming Calls Only” option.
• The menu updates to show all B channels and the back up CO lines
• Select the required lines to be reserved for incoming calls only.
• In default no lines are programmed.
Note: If 23 B-Channels are available and 10 lines are selected then a total of 13 B-Channels are
available to extensions to select for outgoing calls.
If a user selects a Line key of a line that is set as Incoming only, busy tone is returned and the message
'Restricted' is shown on the display.
INCOMING CALLS ONLY WHEN E1 PRI IS
PROGRAMMED
When Incoming only is selected when the switch is equipped with a PRI the display updates showing the
B-Channels, CO lines and IP Trunks.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “Incoming Calls Only” is displayed.
• Select “Incoming Calls Only” option.
• The menu updates and shows “PRI Access”, the back up CO lines and IP Trunks installed.
• Select the required lines to be reserved for incoming calls only.
In default no lines are programmed.
128