Mitel 3000 Administrator's Manual

Mitel 3000
Administrator’s Manual
• Select “Name Programming”.
• From the extension menu, select the extension you want to name and enter the name as described on
page
27. Up to ten characters (including spaces) can be entered for each name.
• When the name is entered, select “Confirm”. You will be presented with the extension menu and can
continue programming other names.
Press the speakerphone key to finish programming.
CLASS-OF-SERVICE
Each extension can be programmed for a Class-of-Service. This determines the type of call the extension is
allowed to dial. Four tables, which can be programmed with up to fifty codes each, are used to implement
six Classes-of-Service.
1. By default, all extensions are in Class 1, that is, they have no restriction placed on them.
2. An extension placed in Class 2 is restricted from dialing the codes programmed in Table 2. (Table 2
would typically be programmed with the international access code 00).
3. An extension placed in Class 3 is restricted from dialing the codes programmed in Tables 2 and 3.
(Table 3 would typically be programmed with non-local national access codes).
4. An extension placed in Class 4 is restricted to dialing internal and emergency calls only. (Emergency
numbers should be programmed See page
35 ).
5. An extension can be placed in Class 5 in addition to being in Class 2 or 3. In this case, the codes
programmed in Table 5 are allowed.
6. An extension can be placed in Class 6 in addition to being in Class 1, 2 or 3. In this case, the codes
programmed in Table 6 are restricted.
The following table shows the types of restriction for the different Classes-of-Service available:
Type of restriction Table Class
No restriction - 1
Restrict codes in Table 2 Table 2 2
Restrict codes in Table 2 and 3 Table 3 3
Internal and emergency calls only - 4
Allowed codes that can be combined with Class 2 or 3 Allowed
Table
5
Restricted codes that can be combined Class 1, 2 or 3 Restricted
Table
6
Note: The emergency codes cannot be restricted.
Note: Both Classes 5 and 6 can be associated with the same extension.
Note: Class 5 cannot be associated with Class 4 extensions.
To Program Class-of-Service Tables
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Press the Scroll Down key () until “Class Codes” is displayed.
• Select “Class Codes”.
• Select the “Table” to which you want to assign codes (Table 2, 3, Allowed Table, or Restricted Table).
• Select an “Index Number” and enter the code.
94

Mitel 3000 Specifications

General

Brand	Mitel
Model	3000
Category	Telephone System
Language	English