Call Features
Page 54 Mitel
®
5312/5324 IP Phone User Guide – Issue 3, February 2011
Using Remote Programming
If the Configuration Assistant feature is enabled for your system, Mitel recommends that you
use Configuration Assistant instead of the Remote Programming feature described in this
section. Configuration Assistant offers an enhanced, voice guided configuration portal that
provides easy-to-use, remote access to the Call Forwarding, Dynamic Extension Express, and
DND features. See page 49 for using Configuration Assistant.
To use Remote Programming to access these features from another system phone or an
external phone, follow the instructions in this section.
4
Changing the Dynamic Extension Express Settings
See “Using Dynamic Extension Express” on page 39 for more information about Dynamic
Extension Express.
To enable Dynamic Extension Express using Remote Programming:
1. Do one of the following:
Call your DISA number (provided by the system administrator). If necessary, enter
your DISA security code.
Use any phone on the system.
2. Dial 359.
3. Enter your extension number.
4. Enter your station passcode followed by #. See page 50 for details on setting up a
station passcode for your extension.
5. Dial 363 (Dynamic Extension Express On).
To disable Dynamic Extension Express using Remote Programming:
Follow steps 1. - 4. above, dial 362 (Dynamic Extension Express Off), and then hang up.
4. This feature may or may not be enabled for your system.
NOTE
A Direct Inward System Access (DISA) number is required to use Remote
Programming from an external phone. Contact your system administrator for more
information.
To Next Page
Loading...
