UC360 Administration Guide
SIP Proxy Server
The IP address (IPv4) of the SIP Proxy server.
Mac Address
The hardware address associated with the network interface on the UC360.
Phone IP Address
The UC360 requires an IP address. This is an IPv4 address and it is recommended that the
address selected be in the same subnet as the local ethernet camera.
Default Gateway IP Address
This is the IP address (IPv4) of the gateway (or default router) that allows access to other
subnets.
Subnet Mask
Consult with the network administrator as to how this should be set.
VLAN ID
This field is used by the administrator to set the VLAN ID. The default setting for this field is no
value (blank).
Note: If a VLAN ID is not entered into this field, then the L2 priority settings will not take effect.
L2 Priority Voice
This screen allows the administrator to set the L2 priority for Voice packets. A value of 6 is
recommended. For further details, see section on UC360 Quality of Service Settings.
L2 Priority Signaling
This screen allows the administrator to set the L2 priority for Signaling packets. A value of 3 is
recommended. For further details, see section on UC360 Quality of Service Settings.
L2 Priority Multimedia
This screen allows the administrator to set the L2 priority for Multimedia packets. A value of 4
is recommended. For further details, see section on UC360 Quality of Service Settings.
DSCP Voice
This screen allows the administrator to set the L3 priority for Voice packets. A value of 46 is
recommended. For further details, see section on UC360 Quality of Service Settings.
To Next Page
Loading...
