What does Mitsubishi Electric CR800-R Controller error C0240 mean and how to resolve it?
Mitsubishi Electric Controller error C0240 means that the safety function is disabled. Although the safety logic is configured, the relevant safety functions are disabled. You should delete the safety logic or enable the safety functions.
How to fix Mitsubishi Electric CR800-R error H8291?
If the Mitsubishi Electric Controller shows error H8291, it means the safety connection failed to establish. Verify the master station's condition, inspect network devices along the communication path, and check the wiring. You can also adjust the timeout time settings using the parameter "SCESTTM".
What causes Mitsubishi Electric Controller error H230n and how to fix it?
Mitsubishi Electric Controller error H230n (where 'n' is an axis number) indicates that the speed monitor detected the speed over. Check the robot movement or the monitoring speed setting. Also, check that the deceleration delay (parameter SLSDLY) is not too short.
What to do if Mitsubishi Electric Controller displays error H220m?
If the Mitsubishi Electric Controller shows error H220m, it means the SLP detected the robot position CMD over the monitoring plane. Please confirm the robot movement or related parameter setting.
How to fix Mitsubishi Electric CR800-R error H0255 *?
Mitsubishi Electric Controller error H0255 * means that the IP address of the host station of the safety communication function (CC-Link IE TSN) does not match the setting value of the network module. To fix this, check and correct the IP address settings of the host station for safety parameter communication settings, then cycle the power.
How to resolve Mitsubishi Electric CR800-R error H0254 *?
Mitsubishi Electric Controller error H0254 * indicates that the master station IP address of the communication destination of the safety communication function (CC-Link IE TSN) does not match the setting value of the network module. Check and correct the IP address settings of the master station for safety parameter communication settings, then cycle the power.
Why does my Mitsubishi Electric CR800-R Controller show error H0251 *?
Mitsubishi Electric Controller error H0251 * appears because both safety IO and safety communication are set to valid, but they cannot be used together. You should disable either safety IO or safety communications.
What does Mitsubishi Electric CR800-R error H0250 * mean and how to resolve it?
Mitsubishi Electric Controller error H0250 * indicates that both Safety IO and Safety comm. are disabled. To enable the safety function, enable either safety IO or safety communications.
What causes Mitsubishi Electric Controller error H0241 * and how to fix it?
Mitsubishi Electric Controller error H0241 * indicates a fault in safety communication. Try turning the power OFF and then ON again. If the error persists, this error also occurs when the machine lock function and controller CPU drive mode are used. Disable the function/mode, then cycle the power of the robot controller.
What does Mitsubishi Electric Controller error H0230 * mean and how to fix it?
Mitsubishi Electric Controller error H0230 * indicates errors in the safety parameter value. To resolve this, check the parameter setting shown in (xxxxx) of the error message and set it to an appropriate value.
General| Maximum Axes | 8 |
|---|---|
| Protection Class | IP20 |
| Compatible Robots | MELFA Robots |
| Communication Interface | Ethernet |
| Programming Language | MELFA-BASIC V |
| Operating Temperature | 0 to 50°C |
| Storage Temperature | -20°C to 60°C |
To Next Page