3-81 Pneumatic hand interface
3 Controller
■ Installation method
This is mounted in the controller.
Attach the pneumatic hand interface (2A-RZ365/2A-RZ375) to the CNHNDOUT/CNHND connector of the hand
interface relay card (2D-TZ315) securely. Refer to separate "Instruction Manual/ Controller setup, basic
operation, and maintenance" for details on the installing method.
Fig.3-32 ： Installation of the pneumatic hand interface （CR2DA-700）
（2A-RZ365）
（2D-TZ315）
A
View A
CNHNDOUT
CNHND
CNHND
CNHNDOUT
Pneumatic hand interface
Hand interface relay card
M4x2
Pneumatic hand interface
Hand interface relay card
<CR2DA-700>
(2A-RZ365/2A-RZ375)
To Next Page
Loading...
