3 PROGRAMMABLE CONTROLLER SETTINGS
3.4 Communication Settings of GX Works3
24
3
5.
Select [No Specification] of "Target Station", and then click [Communication Test]. When the connection has succeeded,
click [OK].
When the communications test detects a connection failure, perform the following.
• Check the power supplies of the programmable controller and the servo amplifiers, wiring with Ethernet cables.
• Check the IP address and the subnet mask of the personal computer.
• Initialize the programmable controller.
For how to initialize the programmable controller, refer to the following.
GX Works3 Operating Manual [18.6 Initializing/Clearing a Memory]
To Next Page
Loading...
