32 MEMORY SPECIFICATIONS
32.4 Files
533
32
In SAFETY MODE
The following lists file operations which are available for each file type in SAFETY MODE.
: Available, : Not available, : N/A
*1 To write files to the programmable controller, use the write function when the operating status of the Safety CPU is STOP. When the
operating status is RUN, use the online change function. When the Safety CPU operating status is RUN, only the standard programs
registered in the CPU parameter can be written to the programmable controller.
*2 Operation is possible only when the operating status of the Safety CPU is STOP/PAUSE. If performed in RUN state, the operating status
of the Safety CPU is changed by the remote STOP function, and then the operation continues.
*3 This indicates operations performed using the CPU Module Logging Configuration Tool.
*4 This parameter relates to safety control inside the CPU parameters. ( Page 936 Safety CPU parameters)
This item is yellow in the engineering tool CPU parameters.
*5 Writing is possible in file units, however, it is not possible to select files together with parameter files or files relating to safety and then
write to the programmable controller CPU. If writing in file units, write after clearing the selection of other parameter files or files relating
to safety, or write after switching to TEST MODE.
File type Operation using engineering tool Operation with SLMP and FTP
server function
Operation with
instructions in
standard programs
Write Read Delete Write Read Delete Write Read
Standard program
*1*5
*2
Standard FB file
*2*5
*2
Standard CPU parameter
System parameter
Standard module parameter
Module extension parameter
*2
*2
Memory card parameter
*2
*2
Device comment
*2
Initial device value
*2
Standard global label setting file
*2*5
*2
Label initial
value file
Global label initial
value file
*2
Local label initial
value file
*2
File register
*2
Event history
Device data storage file
General-purpose data
Data logging
setting file
Common setting
file
*3
*3
*3
Individual setting
file
*3
*3
*3
Remote password
*2
*2
Safety program
Safety FB file
Safety CPU parameter
*4
Safety module parameter
Safety global label setting file
Standard/safety shared label setting
file
To Next Page
Loading...
