NOTE
l
The initial (default) setting is “Auto reset
mode”.
Changing the fuel consumption
display unit
The display unit for fuel consumption can be
switched. The distance, speed, and amount
units are also switched to match the selected
fuel consumption unit.
1. Press and hold the multi-information
meter switch for about 2 seconds or
more to switch from the setting mode
screen to the menu screen.
Refer to “Changing the function settings
(when the ignition switch or the opera-
tion mode is ON)” on page 5-18.
2. Lightly press the multi-information me-
ter switch to select “AVG UNIT” (fuel
consumption display setting).
3. Press and hold the multi-information
meter switch for about 2 seconds or
more to display “AVG UNIT” (fuel con-
sumption display unit setting).
4. Lightly press the multi-information me-
ter switch to switch in sequence from
km/L → L/100 km → mpg (US) → mpg
(UK) → RETURN → km/L.
5. Press and hold the multi-information
meter switch for about 2 seconds or
more to change the setting to the selec-
ted unit.
NOTE
l
The display units for the driving range, the
average fuel consumption, the average speed
and the momentary fuel consumption are
switched, but the units for the indicating
needle (speedometer), the odometer and the
tripmeter will remain unchanged.
l
The memory of the unit setting is erased if
the battery is disconnected, and it returns au-
tomatically to L/100 km.
Multi-information display
5-21
OGAE19E1
Instruments and controls
5
To Next Page
Loading...
