Mitsubishi ASX 2019

If the turn-signal lever is operated to the side
where the BSW lamp is illuminated, the
BSW lamp will blink and the system will
beep 3 times to alert the driver.
NOTE
l
The BSW lamp in the outside rear-view mir-
ror may come on or blink in the following
conditions.
•
When driving very near the guardrail or a
concrete wall.
•
When driving near the entrance and outlet
of a tunnel or very near the wall or near
the evacuation area inside a tunnel.
•
When turning at an intersection in a town
area.
•
Under adverse weather conditions (rain,
snow, sand storm etc.).
•
When driving while your vehicle is blow-
ing up water, snow, sand, etc., on the
road.
NOTE
•
When driving near a kerb, pothole and
tramline.
l
Set the BSW to OFF when towing.
l
The BSW lamp in the outside rear-view mir-
ror may not be visible due to strong direct
sunlight or the glare from the headlamps of
vehicles behind you during night driving.
System problem warning
If a problem occurs with the system, a visual
warning specific to the type of the problem is
given together with an audible alarm.
The warnings are combined with the Rear
Cross Traffic Alert (RCTA) system.
When there is a malfunction in
the system or the sensor
When the warning display appears, the BSW
does not operate normally because there are
some malfunctions in the system or the sen-
sor. Have the vehicle inspected at a
MITSUBISHI MOTORS Authorized Service
Point as soon as possible.
NOTE
l
When the warning display appears, the BSW
will be deactivated.
When the sensor is temporarily
not available
When the warning display appears, the sensor
is temporarily not available for some reason
such as the environmental condition or in-
crease of the sensor temperature. When the
warning display does not disappear after
waiting for a while, contact a MITSUBISHI
MOTORS Authorized Service Point.
When there are foreign objects
on the sensor
Blind Spot Warning (BSW) (with Lane Change Assist)*
6-58
OGAE19E1
Starting and driving
6