To operate
When the BSW switch is pressed while the
ignition switch is turned to the “ON” position
or the operation mode is put in ON, the in-
dicator (green) will appear on the information
screen of the multi-information display and
the BSW will enter the standby state.
When the BSW switch is pressed again, the
indicator on the information screen of the
multi-information display will then go out
and the BSW will turn off.
If you turn the BSW ON/OFF, the Rear Cross
Traffic Alert (RCTA) also turns ON/OFF at
the same time.
NOTE
l
After the system check screen disappears,
the indicator (green) appears on the infor-
mation screen of the multi-information dis-
play.
Refer to “Information screen (when the igni-
tion switch is turned from the “LOCK” posi-
tion to the “ON” position or the operation
mode is changed from OFF to ON)” on page
5-08.
l
When the ignition switch is turned to the
“LOCK” position or the operation mode is
set to OFF, the selected condition (BSW
ON/OFF) just before setting to OFF is re-
tained.
l
The BSW operates when all of the following
conditions are met.
•
The ignition switch is turned to the “ON”
position or the operation mode is put in
ON.
•
The selector lever is in positions other
than “P” (Park) and “R” (Reverse).
•
The speed of your vehicle is approximate-
ly 10 km/h or higher.
When the sensor detects an ap-
proaching vehicle
When the indicator (green) appears on the
information screen of the multi-information
display, if a vehicle is approaching your vehi-
cle in the detection area, the BSW lamp in
the outside rear-view mirror illuminates.
Blind Spot Warning (BSW) (with Lane Change Assist)*
6-57
OGAE19E1
Starting and driving
6
To Next Page
Loading...
