1Error list
Error no. L3150
1-34
L3150 Error message Cannot Print (INPUT mode)
Cause The file open mode is INPUT, so writing is not possible.
Measures Check the file No. and open mode, and re-execute.
L3170 Error message Cannot Input (OUTPUT mode)
Cause The file open mode is OUTPUT, so writing is not possible.
Measures Check the file No. and open mode, and re-execute.
L3180 Error message System error (array range over)
Cause System error (array range over)
Measures If it comes back, contact your service provider
L3200 Error message This file is read only
Cause The file cannot be read.
Measures Check the contents of the file.
L3210 Error message This variable is write protected
Cause Writing of this variable is prohibited.
Measures Check the variable protection setting.
L3220 Error message Nesting over
Cause A nest-over error occurred in If of the If instruction or For of the For instruction.
Measures Correct the program and re-execute.
L3230 Error message For Next statements unmatch
Cause The No. of For and Next statements do not match.
Measures Correct the program and re-execute.
L3240 Error message "Nesting over (For, While)"
Cause The No. of nesting stages exceeded 16 stages (For, While).
Measures Correct the program.
L3250 Error message While WEnd statements unmatch
Cause The No. of While and WEnd statements do not match.
Measures Correct the program and re-execute.
L3251 Error message Number of jump destination exceeds 32
Cause The number of branches defined exceeded 32.
Measures Correct the program and re-execute.
L3252 Error message If EndIf statements unmatch
Cause If EndIf statements unmatch.
Measures Correct the program and re-execute.
L3253 Error message "Nesting over (If, EndIf)"
Cause The No. of nesting stages exceeded 8 stages (If).
Measures Correct the program and re-execute.
L3254 Error message Select - End Select statements unmatch
Cause Select - End Select statements unmatch.
Measures Correct the program and re-execute.
L3255 Error message If Else statements unmatch
Cause If Else statements unmatch.
Measures Correct the program and re-execute.
L3260 Error message Cannot exec for all slots
Cause Execution with all slots designated is not possible.
Measures Designate an individual slot and try again.
L3270 Error message The command size is exceeded
Cause The command size is exceeded.
Measures Specify within single-byte 256 characters.
Error No. Error cause and measures
To Next Page
Loading...
