Odometer/Tripmeter
E00524500148
The operation method is the same as when the igni-
tion switch is “OFF”.
Refer
to “Odometer/Tripmeter” on page 3-05 for
further details.
Service reminder
E00521300914
This displays the distance and number of
months until the next periodic inspection.
Refer to “Service reminder” on page
3-13.
Engine coolant temperature
display
E00521400410
This
indicates the engine coolant temper-
ature.
If the coolant becomes hot, “
”
will
blink.
Pay careful attention to the engine cool-
ant
temperature display while you are
driving.
CAUTION
l
If
the engine is overheating,
“
”
will blink. In this case, the
bar graph is on the red zone.
lmmediately park the vehicle in
a safe place and take the re-
quired measures. Refer to “En-
gine overheating” on page
6-04.
Driving range display
E00521500697
This
displays the approximate driving
range (how many more kilometres or
miles you can drive). When the driving
range falls below approximately 50 km
(30 miles) , “---” is displayed.
Refuel as soon as possible.
NOTE
l
The driving range is determined
based on the fuel consumption da-
ta. This may vary depending on
the driving conditions and habits.
Treat the distance displayed as
just a rough guideline.
l
When
you refuel, the driving
range display is updated.
However, if you only add a small
amount of fuel, the correct value
will not be displayed.
Fill with a full tank whenever pos-
sible.
l
On rare occasions, the value dis-
played for the driving range may
change if you are parked on an ex-
tremely steep incline. This is due
to the movement of fuel in the
tank and does not indicate any mal-
function.
l
The display setting can be
changed to the preferred units (km
or miles).
Refer to “Changing the function
settings (when the ignition switch
is “ON”)” on page 3-15.
Average speed display
E00521600757
This displays the average speed from the
last reset to the present time.
There are the following 2 mode settings.
For the method for changing the average
speed display setting, refer to “Changing
the function settings (when the ignition
switch is “ON”)” on page 3-15.
Manual reset mode
l
When the average speed is being
displayed, if you hold down the
multi-information meter switch,
the average speed displayed at that
time is reset.
Instruments and controls
3-09
3
To Next Page
Loading...
Need help?
General
