S-AWC (Super-All Wheel Con-
trol) control mode display
screen
E00526100018
The
S-AWC operation status is dis-
played. Refer to “S-AWC (Super-All
Wheel Control) control mode” on page
4-29.
“!” mark display screen (when
the ignition switch is “ON”)
E00520900014
This
is displayed when you press the mul-
ti-information meter switch and switch
the warning display screen.
This mark is also displayed if there is an-
other warning other than the one dis-
played.
When the cause of the warning display
is eliminated, the “!” mark goes out auto-
matically.
NOTE
l
When the “!” mark is displayed,
the warning display screen can be
redisplayed on the information
screen.
Refer to “Information screen
(when the ignition switch is
“OFF”)” on page 3-05.
Refer to “Information screen
(when the ignition switch is
“ON”)” on page 3-08.
Active Stability Control (ASC)
OFF display screen
E00521000474
This
is displayed when the Active Stabil-
ity Control (ASC) is turned off with the
ASC OFF switch.
If there is a fault with the ASC, the ASC
OFF display is shown.
Refer to ““ASC OFF” switch” on page
4-34.
Information screen (when the ignition
switch is “ON”)
E00521100648
Each time you lightly press the multi-information
meter switch, the display screen switches in the fol-
lowing order.
1-
Tripmeter
2-
Tripmeter
3- Service reminder
4- Driving range display, momentary fuel con-
sumption display
5- Average fuel consumption display, momenta-
ry fuel consumption display
6- Average speed display, momentary fuel con-
sumption display
7- S-AWC (Super-All Wheel Control) opera-
tion display
8- Function setting screen
9- Redisplay of a warning display screen
NOTE
l
While driving, the function setting screen is
not displayed even if you operate the multi-
information meter switch.
Always stop the vehicle in a safe place be-
fore operating.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-15.
l
When there is information to be announced,
such as a system fault, the buzzer sounds and
the screen display is switched.
Refer to “Interrupt display screen (when the
ignition switch is “ON”)” on page 3-11.
Instruments and controls
3-08
3
To Next Page
Loading...
