NOTE
l
Warning
display screens with a “
” or “ ”
mark displayed in the upper right of the
screen can be switched. If you want to switch
the display, press the multi-information me-
ter switch as follows.
“ ”: Press lightly.
“ ”: Press for about 2 seconds or more.
Redisplay of a warning display screen
When the “!” mark is displayed, if you lightly press
the multi-information meter switch a few times, the
warning display screen you switched from is redis-
played.
Refer to “Information screen (when the ignition
switch is “OFF”)” on page 3-05.
Door ajar warning display screen
(when the ignition switch is “OFF”)
E00520600369
If any of the doors or the trunk lid is not complete-
ly closed, this displays the open door or trunk lid.
1- Doors and trunk lid are closed
2-
Doors or trunk lid is open
Information screen (when the ignition
switch is turned from “OFF” to “ON”)
E00520700722
When
the ignition switch is turned to the “ON” po-
sition, the display screen switches in the following
order.
1- Screen when the ignition switch is “OFF”
2-
System check screen
3- Screen when the ignition switch is “ON”
System check screen
When the ignition switch is turned to the “ON” po-
sition, the system check screen is displayed for
about 4 seconds. If there is no fault, information
screen (when the ignition switch is “ON”) is dis-
played.
If there is a fault, the screen changes to warning dis-
play.
Refer to “Warning
display list (when the ignition
switch is “ON”)” on page 3-26.
NOTE
l
The
system check screen display varies de-
pending on the customer’s equipment.
Service reminder
When the time for periodic inspection arrives, the
warning display is displayed for a few seconds af-
ter the ignition switch “ON”. Refer to “Service re-
minder” on page 3-06.
Instruments and controls
3-07
3
To Next Page
Loading...
