Mitsubishi Lancer Evolution User Manual

1. Press and hold the multi-information meter
switch for about 2 seconds or more to switch
from the setting mode screen to the menu
screen.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-15.
2. Lightly press the multi-information meter
switch to select “AVG UNIT (fuel consump-
tion display setting)”.
3. Press
and hold the multi-information meter
switch for about 2 seconds or more to dis-
play “AVG UNIT” (fuel consumption dis-
play unit setting).
4. Lightly
press the multi-information meter
switch to switch in sequence from km/L →
L/100 km → mpg (US) → mpg (UK) → RE-
TURN → km/L.
5. Press
and hold the multi-information meter
switch for about 2 seconds or more to change
the setting to the selected unit.
NOTE
l
The display units for the driving range, the
average fuel consumption, the average speed
and the momentary fuel consumption are
switched, but the units for the indicating nee-
dle (speedometer), the odometer and the trip-
meter will remain unchanged.
l
The memory of the unit setting is erased if
the battery is disconnected, and it returns au-
tomatically to L/100 km.
The distance and speed units are also switched in
the following combinations to match the selected
fuel consumption unit.
Fuel consump-
tion
Distance (driv-
ing range)
Speed (average
speed)
L/100 km km km/h
mpg (UK) mile (s) mph
mpg (US) mile (s) mph
km/L km km/h
Changing the temperature unit
E00523100567
The display unit for temperature can be switched.
1. Press
and hold the multi-information meter
switch for about 2 seconds or more to switch
from the setting mode screen to the menu
screen.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-15.
2. Lightly press the multi-information meter
switch to select “
”
(temperature unit set-
ting).
Instruments and controls
3-17
3
OGEE12E1

Mitsubishi Lancer Evolution Specifications

General

Brand	Mitsubishi
Model	Lancer Evolution
Category	Automobile
Language	English