3. Press and hold the multi-information meter
switch for about 2 seconds or more to switch
in sequence from °C → °F → °C.
The setting is changed to the selected temper-
ature unit.
NOTE
l
If the battery is disconnected, the unit setting
is erased from memory and is automatically
set to °C.
Changing the display language
E00523200630
The language of the multi-information display can
be switched.
1. Press
and hold the multi-information meter
switch for about 2 seconds or more to switch
from the setting mode screen to the menu
screen.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-15.
2. Lightly press the multi-information meter
switch to select “LANGUAGE” (language
setting).
3. Press and hold the multi-information meter
switch for about 2 seconds or more to dis-
play “LANGUAGE” (language setting).
4. Lightly press the multi-information meter
switch to select the desired language.
5. If you hold down the multi-information me-
ter switch for about 2 seconds or more, the
setting is changed to the selected language.
NOTE
l
The memory of the language setting is erased
if the battery is disconnected, and it returns
automatically to ENGLISH or RUSSIAN.
l
If “---” is selected in the language setting, a
warning message is not displayed when there
is a warning display or interrupt display.
Changing the language cooperative control*
E00523300530
The language used in MITSUBISHI Multi-Commu-
nication
System (MMCS) (if so equipped) or the
Bluetooth
®
2.0 interface (if so equipped) can be
changed automatically to the same language as that
shown in the multi-information display.
1. Press and hold the multi-information meter
switch for about 2 seconds or more to switch
from the setting mode screen to the menu
screen.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-15.
2. Lightly
press the multi-information meter
switch to select “ ” (language cooperative
control).
3. Press
and hold the multi-information meter
switch to switch in sequence from A or 1 (lan-
guage cooperation enabled) → M, 2 or P (lan-
guage cooperation disabled) → A or 1 (lan-
guage cooperation enabled).
The setting is changed to the selected condi-
tion.
NOTE
l
The memory of the language cooperative con-
trol is erased if the battery is disconnected,
and it returns automatically to A or 1 (lan-
guage cooperation enabled).
l
The language display modified with the lan-
guage setting can be switched in the follow-
ing manner.
Instruments and controls
3-18
3
To Next Page
Loading...
Need help?
General
