• Activating the operation confirmation
function (blinking of the turn-signal
lamps) only during locking, or only dur-
ing unlocking.
• The confirmation function (this indicates
locking or unlocking of the doors with
the blink of the turn-signal lamps) can be
deactivated.
• The number of times the turn-signal
lamps are blinked by the confirmation
function can be changed.
l
The keyless entry system does not operate in
the following conditions:
• The key is left in the ignition switch.
• The door is open.
l
The remote control switch will operate with-
in about 4 m from the vehicle. However, the
operating range of the remote control switch
may change if the vehicle is located near a
power station, or radio/TV broadcasting sta-
tion.
l
If either of the following problems occurs,
the battery may be exhausted.
• The remote control switch is operated at
the correct distance from the vehicle, but
the doors are not locked/unlocked in re-
sponse.
• The trunk lid cannot be opened.
• The indication lamp (4) is dim or does
not come on.
For further information, please consult
your MITSUBISHI MOTORS Author-
ized Service Point.
If you replace the battery yourself, refer
to “Procedure for replacing the remote
control switch battery” on page 1-05 .
l
If
your remote control switch is lost or dam-
aged, please contact your MITSUBISHI
MOTORS Authorized Service Point for a re-
placement remote control switch.
l
If you wish to add a remote control switch,
please contact your MITSUBISHI MOTORS
Authorized Service Point. A maximum of 8
remote control switches are available for
your vehicle.
Setting of door unlock function (vehi-
cles equipped with the central door
lock switch)
E00310300198
The door unlock function can be set to the follow-
ing two conditions.
Each
time the door unlock function is set, a chime
will sound to tell you the condition of the door un-
lock function.
Number of
chimes
Condition
One chime All doors unlock
Two chimes Driver’s door unlock only
1. Remove the key from the ignition switch.
2. Place
the combination headlamps and dipper
switch in the “OFF” position, and leave the
driver’s door open.
3. Press the LOCK switch (1) for 4 to 10 sec-
onds and press the UNLOCK switch (2) dur-
ing this time.
4. Release in sequence the LOCK and UN-
LOCK switches within 10 seconds of press-
ing the LOCK switch in step 3.
NOTE
l
On
vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the ad-
justment. Refer to the separate owner’s man-
ual for details.
Procedure for replacing the remote
control switch battery
E00309500174
1. Before
replacing the battery, remove static
electricity from your body by touching a met-
al grounded object.
2. Remove the screw (A) from the remote con-
trol switch.
3. With
the MITSUBISHI mark facing you, in-
sert the clothcovered tip of a straight blade
(or minus) screwdriver into the notch in the
Locking and unlocking
1-05
1
To Next Page
Loading...
Need help?
General
