EasyManuals Logo

Mitsubishi Lancer Evolution User Manual

Mitsubishi Lancer Evolution
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
(Since the ignition switch is in the “LOCK”
position, washer fluid will not be sprayed.)
4. After
approximately 10 seconds, the buzzer
will make a sound. Keep the windscreen wip-
er and washer switch pulled towards you.
(If the windscreen wiper and washer switch
was released, the setting change mode would
be cancelled. To start over, perform the pro-
cedure again from step 3.)
5. When the buzzer stops, with the windscreen
wiper and washer switch still pulled towards
you, press the UNLOCK switch (A) on the re-
mote control switch to select the security
alarm settings mode.
Except for vehicles with the keyless operation system
Vehicles equipped with the keyless operation system
The settings mode can be toggled by press-
ing
the UNLOCK switch. The mode can
be confirmed from the number of times
the buzzer sounds.
Number of
times the buz-
zer sounds
Security alarm settings mode
1 Alarm inactive
2 Alarm active
6. Any
of the following operations can be used
to terminate the system settings change mode.
Releasing
the windscreen wiper and
washer switch.
Closing the driver’s door.
Inserting the key into the ignition
switch.
Placing the lamp switch in any posi-
tion other than “OFF”.
Allowing 30 seconds to pass without
making any changes to the settings.
The ignition switch is put into the
“LOCK” (PUSH OFF) position. (vehi-
cles with the keyless operation system)
NOTE
l
If anything with regard to making changes to
the security alarm system settings is hard to
understand, please consult your
MITSUBISHI MOTORS Authorized Service
Point.
l
Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the “active” mode.
Setting the system
E00301700721
Follow the procedure below to set the system to the
system armed mode.
1. Turn
the ignition switch to the “LOCK” posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
2. Exit the vehicle and close all of the doors,
the trunk lid and the bonnet.
3. Press the LOCK switch (A) on the remote
control switch of the keyless entry system or
the keyless operation system, the driver’s or
front passenger’s door lock/unlock switch
(B) in order to lock all the doors.
Locking and unlocking
1-31
1
OGEE12E1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi Lancer Evolution and is the answer not in the manual?

Mitsubishi Lancer Evolution Specifications

General IconGeneral
BrandMitsubishi
ModelLancer Evolution
CategoryAutomobile
LanguageEnglish

Related product manuals