Mitsubishi MELSEC Q Series Programming Manual

5-22
OUT T,OUTH T
5.3.2 Timers (OUT T,OUTH T)
OUT T,OUTH T
*1: The value setting for the timer cannot be designated indirectly.
See Section 3.4 for further information on indirect designation.
*2: Timer values can be set only as a decimal constant (K). Hexadecimal constants (H) and real numbers
cannot be used for timer settings.
Function
(1) When the operation results up to the OUT instruction are ON, the timer coil goes ON and the
timer counts up to the value that has been set; when the time up status (total numeric value
is equal to or greater than the setting value), the contact responds as follows:
: Timer number (bit)
Set value : Value set for timer (BIN 16 bits *1)
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn
Constants
K
Other
Bit Word Bit Word
(Only T)
–– –– –– –– –– –– ––
Set value ––
(Other
than T, C)
–– ––
*2
––
A Contact Continuity
B Contact Non-continuity
Basic
Process
High
performance
Redundant Universal LCPU
T0
Set value
Setting in the range
from 1 to 32767 is valid.
K50
T0
Set value
Data register value in
the range from 1 to
32767 is valid.
D10
T0
Set value
Setting in the range
from 1 to 32767 is valid.
K50
H
T0
Set value
Data register value in
the range from 1 to
32767 is valid.
D10H
ST0
Set value
Setting in the range
from 1 to 32767 is valid.
K50
ST0
Set value
Data register value in
the range from 1 to
32767 is valid.
D10
ST0
Set value
Setting in the range
from 1 to 32767 is valid.
K50H
ST0
Set value
Data register value in
the range from 1 to
32767 is valid.
D10H
OUT T
OUTH T
OUT ST
OUTH ST
Command
Command
Command
Command
Command
Command
Command
Command
(High-speed retentive timer)
(Low-speed timer)
(High-speed timer)
(Low-speed retentive timer)
D
D
@D0
T0
Indirect designation is
not permitted.

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English