Mitsubishi MELSEC Q Series Programming Manual

5-53
END
1
2
3
4
5
6
7
8
5.6 Termination Instructions 5.6.2 End sequence program (END)
5.6.2 End sequence program (END)
END
Function
(1) Indicates termination of programs, including main routine program, subroutine program, and
interrupt programs.
Execution of the END instruction will cause the CPU module to terminate the program that
was being executed.
(2) The END instruction cannot be used during the execution of the main sequence program.
If it is necessary to perform END processing during the execution of a program, use the
FEND instruction.
(3) When programming in the ladder mode of a peripheral device, it is not necessary to input the
END instruction.
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn Constants Other
Bit Word Bit Word
–– ––
Basic
Process
High
performance
Redundant Universal LCPU
END
END
Sequence program
END
0

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English